"전기 회로"의 두 판 사이의 차이

수학노트
둘러보기로 가기 검색하러 가기
(→‎노트: 새 문단)
 
 
(같은 사용자의 중간 판 하나는 보이지 않습니다)
52번째 줄: 52번째 줄:
 
===소스===
 
===소스===
 
  <references />
 
  <references />
 +
 +
==메타데이터==
 +
===위키데이터===
 +
* ID :  [https://www.wikidata.org/wiki/Q132629 Q132629]
 +
===Spacy 패턴 목록===
 +
* [{'LOWER': 'electrical'}, {'LEMMA': 'network'}]
 +
* [{'LOWER': 'electrical'}, {'LEMMA': 'circuit'}]
 +
* [{'LEMMA': 'circuit'}]

2021년 2월 17일 (수) 00:59 기준 최신판

노트

위키데이터

말뭉치

  1. To design any electrical circuits, electrical engineers need to be able to predict the voltages and currents in the circuit.[1]
  2. This method increases both time and cost efficiency since it does not require the engineer to build every circuit prototype in order to test it.[1]
  3. In more complex circuits, engineers need to turn to circuit simulation software.[1]
  4. When faced with a new circuit, the software first tries to find a steady state solution.[1]
  5. Due to cold snap and rising coal prices, residents use electricity to heat their homes, as a result there is a large load on the electrical network during pick hours - from 19.00 until 23.00.[2]
  6. The interconnection of various active and passive components in a prescribed manner to form a closed path is called an electric circuit.[3]
  7. The system in which electric current can flow from the source to the load and then back to the other terminal of the source is referred to as an electric circuit.[3]
  8. Protection devices for protecting the circuit from abnormal conditions and these are mainly electric fuses, MCBs, switchgear systems.[3]
  9. Conducting path to carry electric current from one point to other in the circuit and these are mainly wires or conductors.[3]
  10. Network is the most used word in an electric or electronic circuit while solving a circuit problem or creating a balanced circuit.[4]
  11. A network does not require to have a closed path, the open circuit also can be called as a network.[4]
  12. In such a way all the networks are not a circuit (example: open circuit cannot be called as circuit and it can be called as a network) and all the circuit can be called as network.[4]
  13. An electrical network can be identified by four circuit names such as Node, Branch, Loop and Mesh.[4]
  14. A simple electric circuit made up of a voltage source and a resistor.[5]
  15. An electrical circuit is a network consisting of a closed loop, giving a return path for the current.[5]
  16. A resistive circuit is a circuit containing only resistors and ideal current and voltage sources.[5]
  17. A network that contains active electronic components is known as an electronic circuit.[5]
  18. A Circuit which contains on many electrical elements such as resistors, capacitors, inductors, current sources and Voltage source (both AC and DC) is called Complex network.[6]
  19. Circuit or electrical circuit is a close loop path giving a return path for the current.[6]
  20. If circuit elements are series connected in some parts and parallel in others, that would be a series-parallel circuit.[6]
  21. In this circuit, electrical elements are connected such a way that undefined in term of Series, parallel or Series Parallel configuration.[6]
  22. So we can also say if the parameters of an electrical circuit are constant, they do not change with the change of voltage and current then that circuit.[7]
  23. Actually, most of the cases the property of an electrical circuit depends on the property of connected elements.[7]
  24. The purpose of the first application is to diagnose faults in an electrical network.[8]
  25. In other words, the supplies must be linked up in different parts of the country by long-distance transmission, and the whole country covered with an electrical network.[8]
  26. An electrical network was established in 1964 and access to telecommunications is fully restored since 2006.[8]
  27. Any power grid is composed of 100s of electrical elements such as transmission lines, transformers, circuit breakers and shunt impedances.[9]
  28. This sheet describes the basics of electrical network analysis.[10]
  29. The description focuses on the modeling of a circuit for static or dynamic analysis using nodal analysis.[10]
  30. This work demonstrates how such calculations can be performed using the eigenvalues and eigenvectors of the Laplacian matrix which describes the connectivity of the electrical network.[11]
  31. In recent years, the unique public lighting network Gibraltar has, is maintained by the Electrical Network Division and has seen a change to the benefits of low energy, high efficiency lighting.[12]
  32. The Drawing Office currently manned by a team of 3 engineers, technical and skilled grades, also forms part of the Electrical Network Division.[12]
  33. The US contributes 75% of the equipment required for the Steady State Electrical Network (SSEN), excluding cables and emergency power.[13]
  34. The Steady State Electrical Network is an AC power substation and distribution system that supplies electrical power to all ITER conventional systems and facilities.[13]
  35. The Steady State Electrical Network at the ITER site was first energized in 2017 and fully online in 2018.[13]
  36. However, if the fibers would act as independent conductive pathways, the resulting electrical network would be highly vulnerable to disruption.[14]
  37. An electric circuit contains a closed path for providing a flow of electrons from a voltage source or current source.[15]
  38. Active Elements deliver power to other elements, which are present in an electric circuit.[15]
  39. Active Elements are the network elements that deliver power to other elements present in an electric circuit.[15]
  40. A Node is a point where two or more circuit elements are connected to it.[15]
  41. The electrical network has to become intelligent to adapt to these changes.[16]
  42. In France, the brand worked on the Cotentin-Maine line, to connect the future EPR Flamanville nuclear reactor to the nation’s RTE electrical network.[16]
  43. Compared to general networks (or systems), an electrical network has its own characteristics that limit the wide application of CNT.[17]
  44. In the existing methods, the topological structures are employed to assess the electrical network vulnerability based on the CNT on the original physical networks.[17]
  45. The cup represents the topological structure of an electrical network and the water in the cup represents the operational status, as shown in Figure 2.[17]
  46. The optimal/appropriate point corresponds to a certain electric load level in the electrical network, represented by the water level in the cup.[17]

소스

  1. ↑ 1.0 1.1 1.2 1.3 Electrical network
  2. ↑ Electrical network
  3. ↑ 3.0 3.1 3.2 3.3 Electric Circuit or Electrical Network
  4. ↑ 4.0 4.1 4.2 4.3 What is Electrical Network
  5. ↑ 5.0 5.1 5.2 5.3 Electrical network
  6. ↑ 6.0 6.1 6.2 6.3 What is an Electric Circuit? Types of Circuits, Network & Parts Of Circuit
  7. ↑ 7.0 7.1 Electrical CIRCUIT and NETWORK Differences, Definition, Types
  8. ↑ 8.0 8.1 8.2 electrical network
  9. ↑ Electrical Networks: An Introduction
  10. ↑ 10.0 10.1 Electrical network analysis: Using nodal method
  11. ↑ Calculating Nodal Voltages Using the Admittance Matrix Spectrum of an Electrical Network
  12. ↑ 12.0 12.1 Electrical Network
  13. ↑ 13.0 13.1 13.2 Steady State Electrical Network
  14. ↑ An Ordered and Fail‐Safe Electrical Network in Cable Bacteria
  15. ↑ 15.0 15.1 15.2 15.3 Network Theory
  16. ↑ 16.0 16.1 Smart grids: Electrical networks that evolve in response to usage
  17. ↑ 17.0 17.1 17.2 17.3 Identification of Two Vulnerability Features: A New Framework for Electrical Networks Based on the Load Redistribution Mechanism of Complex Networks

메타데이터

위키데이터

Spacy 패턴 목록

  • [{'LOWER': 'electrical'}, {'LEMMA': 'network'}]
  • [{'LOWER': 'electrical'}, {'LEMMA': 'circuit'}]
  • [{'LEMMA': 'circuit'}]
원본 주소 "https://wiki.mathnt.net/index.php?title=전기_회로&oldid=51186"